Replies to This Discussion

Permalink Reply by Liz Glitz on September 23, 2009 at 10:41am

sounds good!

• ▶ Reply

Permalink Reply by The CircularPhile on September 27, 2009 at 6:08pm

I tape each half separately and put a 2 inch ring of electrical on each side of the joint, making sure it comes right to the edge, but doesn't go over.

Attachments:

• Picture 080.jpg, 2.2 MB

• ▶ Reply

Permalink Reply by marybeee on September 24, 2009 at 11:56am

Willow-- how small were you able to make with the 3/4 in 160 PSI tubing? I'm definitely hoping to make some collapsible that are smaller if possible... right now i hoop with a 32-34 inch hoop so i was hoping to get one this small for myself, but most of the ones I make to sell are around 38 inches.

Everyone else --If the infinity method doesn't work well for smaller hoops, does anyone know if the other method (#2) works better for the smaller hoops? Thanks!!!

• ▶ Reply

Permalink Reply by Rachel on October 12, 2009 at 11:13am

I had a question about the weight of the tubing. Is a 100 psi lighter then the 160 psi? I wanting to make a kid hoop for my newphews and I believe 100 psi is what I want but pleass correct me if that is wrong.

• ▶ Reply

Permalink Reply by circularlogic on October 12, 2009 at 2:23pm

Yes, the lower the number the lighter (& more flexible) the hoop.

• ▶ Reply

Permalink Reply by Rachel on October 12, 2009 at 7:10pm

circularlogic- Thank you for replying. I had someone tell me that I wanted 160 psi and I am thinking okay great, yet "isn't that weigh more"? So thank you for clearing it up for me.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page